Controls & Steering

SH50941P: Quick connect feature on both sides of helm allow port side helm mount without need for an adaptor. The Quick connect snap in place feature allows both cable and spent travel tube installation with no tools required. Quicker installation...

Round flange allows installation of flush mount helms in an intermediate position so they don't extend all they way out from the dash. Helm pump sold separately.

Fits current Mercury/Mariner outboards (with integral trim) and 1993 and newer Force outboards 40 hp and higher utilizing Mercury style cables (with power trim). Includes 4' trim harness with 3-pin Molex connector. Power trim adapter included to convert...

Use 33C and 43C supreme cables.

For 3300/33C style cables

Will facilitate filling and purging of steering system at a more convenient and accessible area than at a helm pump. Contains thru-dash fitting, waterproof vent plug, elbow fittings and 18" of vinyl tube.

Fitting kit for engine controls.

Comes with single trim switch in handle for trim and trailering. All installations require an Ignition/Choke assembly & Throttle/Shift Cables to complete. Must be used with Gen II Throttle/Shift Cable design (897978A). A power trim extension harness also...

Generation II MPC Panel w/Finger Release Remote ControlComes with 4 ft. trim and trailer switch harness with the 4 pin Molex connector. All installations require a separate ignition switch and throttle/shift cables to complete the installation. Neutral...

Transfer units can be used with Single S, Twin S, Single SR, or Twin SR two lever controls. Recommended where long or difficult cable paths make parallel installations costly and/or difficult. When S or SR two lever controls are used in a...